Panasonic AJ-D610WBP - PB Timing Adjustment; PR Timing Adjustment

ELE-39
8-3. PB Timing Adjustment
BOARD
VIDEO I/F
TP
TP501[AD_Y], TP502[AD_PB]
ADJUST
VR403[PB_TMG]
INPUT
CAMERA (Color Bar)
SMPTE Color Bar
MODE
EE
TAPE
-
M. EQ.
Oscilloscope
SPEC.
A =+/-20nS (CAMERA)
A =+/-50nS (VIDEO IN)
Menu Setting
1. While pressing
[SHIFT], [+],
and
[-]
keys and set
[MENU]
sw to SET.
2. Set the Menu as shown below.
PAGE: SERVICE ADJ.
IF ADJ. :
OFF
3. Adjust
VR403
so that the phase difference A
between
TP501
and
TP502
is 0 +/- 20 nS.
Following Steps are for NTSC Model only.
4. Set the Menu as shown below.
PAGE: MAIN FUNCTION
REC SIGNAL :
VIDEO
5. Supply a SMPTE Color Bar to Video IN.
6. Confirm that the phase difference A is 0 +/- 50 nS.
8-4. PR Timing Adjustment
BOARD
VIDEO I/F
TP
TP501[AD_Y], TP503[AD_PR]
ADJUST
VR406[PR_TMG]
INPUT
CAMERA (Color Bar)
SMPTE Color Bar
MODE
EE
TAPE
-
M. EQ.
Oscilloscope
SPEC.
A =+/-20nS (CAMERA)
A =+/-50nS (VIDEO IN)
Menu Setting
1. While pressing
[SHIFT], [+],
and
[-]
keys and set
[MENU]
sw to SET.
2. Set the Menu as shown below.
PAGE: SERVICE ADJ.
IF ADJ. :
OFF
3. Adjust
VR406
so that the phase difference A
between
TP501
and
TP503
is 0 +/- 20 nS.
Following Steps are for NTSC Model only.
4. Set the Menu as shown below.
PAGE: MAIN FUNCTION
REC SIGNAL :
VIDEO
5. Supply a SMPTE Color Bar to Video IN.
6. Confirm that the phase difference A is 0 +/- 50 nS.
TP501
TP502
A
A
TP503
TP501