Panasonic AJ-D610WBP - Removal of Mechanical Chassis Unit

DIS-2
1-4. Removal of Mechanical
Chassis Unit
1. Remove the Right Side Panel.
2. Disconnect the connectors (A) and (B) on the RF
P.C.Board.
3. Remove the 3 screws (A) and the screw (B) and lay
down the boards.
4. Disconnect the connectors (C), (D),(E),(F),(G) and
(H).
5. Remove the 2 screws (C) for pull out BNC terminal
and disconnect the connector (G) and (H) on the
Rear Jack P.C.Board. Disconnect the connector (I)
on the Mother P.C.Board. and loosen the 2 screws
(D) and remove the 2 screws (E).
Remove the mechanical chassis with care not to
scratch the any connectors and cables.
Note:
When the mechanical chassis unit installed,
confirm the connector P1001 on the Rear Jack
P.C.Board connected correctly.
Screws (A)
Screws (B)
Connector (B)
Connector (A)
Screws (D)
Connector (I)
Connector (H)
Screws (E)
Screws (C)
Connector (G)
Connector (G)
Connector (F)
Connector (E)
Connector (C)
Connector (D)
Connector (H)