Panasonic AJ-D610WBP - PB Level Adjustment; PR Level Adjustment

ELE-13
3-5. PR Level Adjustment
BOARD
ENCODER
TP
P1-B52 PIN (PR_26P)
ADJUST
VR3
SW201, SW1
MODE
CAMERA BAR
M. EQ.
WFM Monitor
SPEC.
NTSC A = 700mV+/-14mV
PAL A = 525mV+/-10mV
1. Connect a
26P connector
to other VCR.
2. Confirm the
SW201 (26P)
is
ON
.
Menu Setting
3. Set
[MENU]
switch to
SET
while pressing
[SHIFT],
[+], and [-]
buttons on the operation panel.
4. Set the menu as shown below.
PAGE : MAIN MENU 1/4
KNEE LEVEL
ITEM : SET UP 25/50 :
7.5%
(NTSC)
5. Adjust
VR3
so that the Level A at
P1-B52
is in the
specification.
<NTSC>
<Note>
Confirm both SW1-1 and SW1-2 is at S side.
<PAL>
<Note>
Confirm both SW1-1 and SW1-2 is at M side.
3-6. PB Level Adjustment
BOARD
ENCODER
TP
P1-A48 PIN (PB_26P)
ADJUST
VR4
SW201, SW1
MODE
CAMERA BAR
M. EQ.
WFM Monitor
SPEC.
NTSC A = 700mV+/-14mV
PAL A = 525mV+/-10mV
1. Connect a
26P connector
to other VCR.
2. Confirm the
SW201 (26P)
is
ON
.
Menu Setting
3. Set
[MENU]
switch to
SET
while pressing
[SHIFT],
[+], and [-]
buttons on the operation panel.
4. Set the menu as shown below.
PAGE : MAIN MENU 1/4
KNEE LEVEL
ITEM : SET UP 25/50 :
7.5%
(NTSC)
5. Adjust
VR4
so that the Level A at
P1-A48
is in the
specification.
<NTSC>
<Note>
Confirm both SW1-1 and SW1-2 is at S side.
<PAL>
<Note>
Confirm both SW1-1 and SW1-2 is at M side.
A
A