Panasonic AJ-D610WBP - 3-16.VIDEO in Level Adjustment; 3-17.MON ENC Level Adjustment

ELE-19
3-16. VIDEO IN Level Adjustment
BOARD
ENCODER
TP
VIDEO OUT
ADJUST
VR105[RET_LEV]
INPUT
Color Bar (GEN LOCK IN)
MODE
CAMERA BAR
M. EQ.
WFM
SPEC.
A = 1V +/- 20mV
1. Supply a composite signal to
GEN LOCK IN
.
Menu Setting
2. Set
[MENU]
switch to
SET
while pressing
[SHIFT],
[+],
and
[-]
buttons on the operation panel.
3. Set the menu as shown below.
PAGE: MAIN MENU 3/4 ->
REC (ASPECT)/PB/RET
ITEM: REC SIGNAL: VIDEO
4. Connect a Waveform monitor to the
VIDEO OUT
,
and adjust
VR105
so that the Level
A
is in the
specification.
5. Return the MENU as follows.
PAGE: MAIN MENU 3/4 ->
REC (ASPECT)/PB/RET
ITEM: REC SIGNAL: CAM
<NTSC>
<PAL>
3-17. MON ENC Level Adjustment
BOARD
ENCODER
TP
VIDEO OUT
ADJUST
VR103[ENC_LEV],EVR
MODE
CAMERA BAR
M. EQ.
WFM
SPEC.
A = 1V +/- 20mV
Menu Setting
1. Set
[MENU]
switch to
SET
while pressing
[SHIFT],
[+],
and
[-]
buttons on the operation panel.
2. Set the menu as shown below.
PAGE: SERVICE ADJ. 1/2
ITEM: ECU CONNECT :
EVR
EVR Setting
Set EVR as shown below.
COM:[1E] DATA:[03] ADR:[00] [Enter]
COM:[1E] DATA:[04] ADR:[00] [Enter]
3. Connect a Waveform monitor to the
VIDEO OUT
,
and adjust
VR103
so that the Level
A
is in the
Specification.
4. Return the MENU as follows.
PAGE: MAIN MENU 3/4 -> VIDEO OUT
ITEM: VIDEO OUT SEL: ENC
CHARACTER: ON
<NTSC>
<PAL>
A
A