Panasonic AJ-D610WBP - Dsp; Encoder; Initial Setting; AD REF Voltage Confirmation

ELE-11
3. DSP / ENCODER
3-1. Initial Setting
1. Set the Camera recorder SW setting as shown
below.
AUTO W/B BAL : OFF
SHUTTER : OFF
GAIN : L
OUTPUT : BAR
WHITE BAL : PRE
2. Connect the cables as shown below with the
camera recorder and the EVR power OFF.
<Note>
! The SCH of the signal generator should be 0
degrees.
! Turn ON the EVR, then turn ON the camera
recorder.
! Set the MENU SW to SET while pressing [SHIFT],
[+], and [-] together on the operation panel.
! Change the PAGE and open the SERVICE ADJ
Menu, then set the ECU CONNECT to EVR. After
setting close the MENU.
! Execute the CAM_TOOL.EXE.
(Refer to ELE-1 <Preparation for Adjustment>)
3-2. AD REF Voltage Confirmation
BOARD
DSP MAIN
TP
TP4
M. EQ.
DVM
SPEC.
DC=2V+/-0.1V
1. Confirm the DC Voltage at TP4 is in the
specification.
<MEMO>
AJ-D610WB