ELE-40
9. RF ADJUSTMENT (1)
(Manual Adjustment)
9-1. System hookup and settings.
1.
Connect the Camera recorder with the RF adjust-
ment system as shown below.
9-2. MENU SETTING
While pressing
[SHIFT], [+],
and
[-]
keys and set
[MENU]
sw to SET.
<DESIGN>
DESIGN : BER_ADJ
: BER_SPEED
: ENV_DET_ADJ
<SERVICE>
SERVICE ADJ 1/2 : ECU_CONNECT
: CONCEAL
: INNER_ECC
: OUTER_ECC
: SERVO_MODE
VTR D/A DATA
Note
The adjustment value for BER_ADJ, BER_SPEED,
ENV_DET_ADJ are returned to original when the cam-
era recorder is turned OFF.
9-3. Notes
<EVR Adjustment>
1. When adjustment is done with EVR while MENU is
ON:
Set the MENU off to store the EVR data before
power off. If power is turned off while MENU is ON,
the stored EVR data is erased.
2. When adjustment is done with EVR while MENU is
OFF.
Set MENU ON and set MENU OFF to store the
EVR data before power off. If power is turned off
without this operation the stored data is erased.
<Blank Tape>
Do not use the blank tape which is recorded by the
VTR without PG Shifter adjustment.
9-4. BYTE ERROR DISPLAY
1. This model equipped a Byte Error Rates Display
function.
2. To execute the Byte Error rate display function, set
to the “DESIGN MENU” as shown below.
PAGE: DESIGN
BER ADJ : ON
3. See figure below for error rate specification.
P4 Connector
RF
VIDEO
OUT
ECU
EVR
Monitor TV
RP EYE
PB HSW
LCD
(Error Rate)
Spectrum
Analyzer
50ohn
term
IN
IN
EXT
TRIG
B.E.R.COUNTER
dB
0
-10
-20
-30
-40
-
∞
CONCEAL
SPEC.
AUDIO = CH1 CH2
BER = L1ch/R1ch L2ch/R2ch
To Next Page
Loading...
