Panasonic AJ-D610WBP - How to Reset Hour Meter; Version Display Operation and Hour Meter Display; DIAG-MENU Display

INF-27
12.DIAG-MENU Display
12-1. Version Display Operation and Hour Meter Display
1. Press the
“SHIFT/ITEM”
and
“+”
buttons of the MENU/Time Code Operation Button (in the door of the right
side panel) simultaneously and set the MENU switch to
“SET”
, and then MENU screen is displayed.
2. Press the
“PAGE”
button a few times until DIAGNOSTIC MENU screen is displayed.
12-2. How to Reset Hour Meter
DIAGNOSTIC screen displays operating condition and software version as mentioned on Operating Instructions.
Drum Running Hours and Threading Times can be reset by HOUR METER RESET menu.
< How to reset >
After select this menu, press UP or DOWN button, and then execute reset function.
< HOUR METER RESET >
DRUM RUNNING RESET
THREADING RESET
< DIAGNOSTIC >
OPERATION : 00000 X10h
DRUM RUNNING : 00000 X10h
THREADING : 00000 X10
VTR SYSCON Ver<T1.05>
CAM SYSCON Ver<2.2>1.0
DATA ROM Ver<1.0>
DV Ver<2.2603>
01.01.01
Operation Time (: 10houre X)
Ctrinder Motor running time.
Operation Hour (: 10HOUR x)
VTR System Control (P-ROM)
Camera System Control (FLASH-ROM)
Micro Computer on Camera System control
DV Micro Computer Version