Panasonic AJ-D610WBP - Adjustment for CCD Assy Replacement; Adjustment Procedures; Auto off Information

INF-26
10. Adjustment for CCD Ass'y Replacement
When replace the CCD Ass'y (Include PRE AMP/CCD
PULSE/DRIVE board), perform the next procedure
with SECTION 3 ELECTRICAL ADJUSTMENT
PROCEDURE.
10-1. Adjustment Procedure
1. Perform the A/D INPUT GAIN of the Pre Process
board.
(Adjust with TEST SAW signal)
2. Perform the DYNAMIC RANGE (AUTO KNEE)
adjustment. It adjust R GAMMA (4) and B
GAMMA (4) of SERVICE ADJ. 2/2 page.
3. Perform the White Shading / Black Shading
adjustment.
4. Perform the FLARE adjustment.
After adjusting the all 4 item, Check camera
performance.
11. Auto off Information
Error No. Meaning Detected Condition Check
04
Fault of Pinch Solenoid
Drive or
Reel Brake Solenoid
Drive.
Drive current is supplied to solenoids
more than 5 seconds.
(Normal : 100msec.)
1. Drive circuits of S* or T* Brake
Solenoids and Pinch Solenoid.
P610-#1 and #3, P605, P608, IC501-
#99
28
Fault of Cleaner
Solenoid Drive
Drive current is supplied to solenoid
more than 30 seconds.
(Normal : max.10sec)
1. Drive circuit of Cleaner Solenoid.
IC501-#98
0B
Supply Reel fault
0C
Take-up Reel fault
The condition that the amount of tape
running is less than one-eighth of
specification according to
operationed mode lasts more than 5
seconds.
1. Reel motor doesn’t rotate.
->Drive circuit : P614(S*)
P615(T*)
2. Reel brake isn’t released.
->Drive circuit : P605(S*)
P608(T*)
3. Cassette is not loaded correctly on a
reel.
4. Tape is stacked to drum.
0D
Capstan fault
The condition that FG frequency is
less than half or more than twice of
specification lasts more than 1.5
seconds.
1. Capstan doesn’t rotate.
->Drive circuit : P616
2. No capstan FG.
->P616-#1 and #3
0E
Cylinder fault
The condition that FG frequency is
less than half or more than twice of
specification lasts more than 3
seconds, even after cylinder has
rotated more than 2 seconds.
1. Cylinder doesn’t rotate.
->Drive circuit : P613
2. No cylinder FG.
->P613-#9
0F
Loading fault
Loading or Unloading is not
completed within less than 10
seconds.
1. Loading motor doesn’t rotate.
->Drive voltage P611
2. Take-up reel torque is over
specification.
Note
: Connectors and ICs are located on Servo board.
S* : Supply Reel
T* : Take-up Reel
# : Pin No.