Panasonic AJ-D610WBP - Page 112

ELE-56
15-9. AGC Level Confirmation
BOARD
AUDIO LCD
TP
AUDIO OUT
ADJUST
-
INPUT
1kHz, -30dBu
Sine Wave / FRONT
MODE
STOP
TAPE
-
M. EQ.
Audio Analyzer-
SPEC.
NTSC:
PAL:
+8.5dBu+/-2.0dB
+2.5dBu+/-2.0dB
1. Set the Camera Recorder SW as shown below.
MONITOR SELECT :
CH1,ST
AUDIO SELECT CH1 :
AUTO
AUDIO SELECT CH2 :
AUTO
AUDIO IN CH1 :
FRONT MIC
AUDIO IN CH2 :
FRONT MIC
2. Confirmation output level at the
AUDIO OUT
is in
the specification.
3. Set the Camera Recorder SW as shown below.
MONITOR SELECT :
CH2,ST
4. Confirm the Output Level at the
AUDIO OUT
is in
the specification.
15-10. Head Phone Level
Confirmation
BOARD
AUDIO LCD
TP
PHONES(Head Phone Output )
ADJUST
-
INPUT
NTSC:
PAL:
1kHz, +4dBu
1kHz, 0dBu
Sine Wave / REAR
(CH1/CH2)
MODE
STOP
TAPE
-
M. EQ.
Audio Analyzer-
SPEC.
more than -20dBu
1. Set the Camera Recorder SW as shown below.
MONITOR SELECT :
4-12,ST
2. Set the
MONITOR VR
to
Maximum position
.
3. Connect a 8 ohm resistor at the
PHONES (Head
Phone Output)
and measure the Output Level,
then confirm the level is in the Specification.