INF-36
12.
Before saving data of compensation, just make
sure whether it has been done or not by pressing
UP & DOWN buttons (ON & OFF) at the
COMPENSATION
in DEFECT COMPENSATION
menu. In the view on the video & viewfinder, there
should not have any white spots.
13.
After compensated completely,
DEFECT
ADJ.MODE
set to “
OFF
”,
COMPENSATION
set
to “
ON
”
MENU
set to “
OFF
” and then turn
POWER
“
OFF
”.
<Note>
When the gain set –3dB/0dB mode, the blemish
compensation is not working. If appear the blemish at
–3/0dB, set the EVR as shown below.
-3dB/0dB ON =
COM : [42], DATA : [FF], ADR : [44]
-3dB/0dB OFF =
COM : [42], DATA : [0F], ADR : [44]
(When set above command, please turn the power of
camera recorder off and on for ignore the blemish
compensation mode.)
After setting the above command, please do the
following operations for memorize the setting in the
FLASH ROM.
1. Open the Service menu, and select the Defect
compensation page.
2. Select the DEFECT ADJ MODE, and set to ON.
3. Close the MENU.
<Note>
1. Explain of MENU Display
MENU ITEM EXPLAIN
DEFECT ADJ MODE
Mode ON/OFF to compensation
mode. (Cursors ON/OFF)
DEFECT NO.
Display the Defect No. (00-15)
for perform.
CURSORS ADJ
V (+/- SW)
H (FF/REW SW)
Indicate of Cursors position.
H: 07FF (Initial offset number)
V: 03FF (Initial offset number)
*Initial offset position is bottom of
the right at picture.
FIELD CONT
Not work.
DUAL PIXEL
Mode ON/OFF to DUAL PIXEL
Compensation.
COMPENSATION
Mode ON/OFF to Blemish
compensation. (Not disappear
Cursors )
Blemish compensation data
initialize.
DATA CLR
NOTE:
For perform to this item, the
“COMPENSATION” item is
require to “ON”. When
“COMPENSATION” item is OFF,
set to item to “ON” and then
Camera-recorders power turn to
the OFF to ON.
2. When set “DEFECT ADJ MODE” to ON, the Gain
mode is automatically changing to +24dB mode.
Compensate the left side of blemish
(Confirm by DUAL PIXELON/OFF)
Blemish compensate completely
White Blemish
To Next Page
Loading...
