ー 162 ー
Advance check sheetIntelligent Controller web settings
Intelligent Controller web settings — Advance check sheet
Dear Client
Thank you for choosing the Intelligent Controller.
This system is fundamentally designed to be connected to an existing intranet or LAN. Before setting up, there
are details to confirm in advance about the client’s PC (network) environment.
Please check the “□” of the applicable items below, and fill in the required items.
Thank you
■
Request
1
Do not connect to the network until the following settings are completed.
2
Use at least Category 5 (*) for the LAN cable.
3
In order to protect the network against unauthorized external access, take security measures such as using
a firewall.
* Communication cable standard established by the American Telecommunications Industry Association (TIA)
and the American Electronic Industries Alliance (EIA)
1. In order to connect with the Intelligent Controller from the web browser of the client’s PC and operate the air con-
ditioner, the following environment is required. Please check the corresponding “□”.
□ Supported browsers: Internet Explorer 11 or later, or Google Chrome
□ Screen resolution: 1280 × 1024 or higher recommended
□ Communication protocol: IPV4 (IPV6 not supported)
□ Do not use DHCP. (In the case of DHCP, it is only possible to use the NTP server time setting and the
alarm mail function. Please fill in
8
(
9
) of 2, and 3)
If everything is checked OK, go to the next step.
2. Confirm network connection environment
1
Do you want to connect the web-ready Intelligent Controller and the PC 1-to-1?
[1-to-1]
□ Yes
⇒
There are no items to fill in in advance.
Our staff will perform setup during the test run. Thank you very much.
□ No
⇒
Go to
2
2
Is the network you want to connect to an existing one?
□ Yes
⇒
Go to
3
□ No
⇒
Go to
6
3
Are you using a DHCP server?
□ Yes
⇒
Go to
4
□ No
⇒
Go to
5
TGR-318_ENG.indb 162 2017/04/06 10:44:44
To Next Page
Loading...
Need help?
General
