ー 174 ー
Outgoing email settingsIntelligent Controller web settings
Set the recipient
Set the destination in the “Email Alarm recipient settings” dialogue.
1. Change the settings.
Item Explanation
Mail address Set the email address to send alarms emails.
The touchscreen keyboard appears when you touch this and you can change the email address.
Valid Users with a check mark in this column will be sent alarm emails.
Adaptor CommuErr Users with a check mark in this column will be sent alarm emails when there is a communica-
tions error with the communication adaptor.
I/D unit Disc. Users with a check mark in this column will be sent alarm emails when an alarm is issned for a
disconnected alarm.
Send test email A test email is sent to the set e-mail address. However, a test email is not sent if the setting for
[Valid], [Adaptor CommuErr], or [I/D unit Disc.] has been changed but the change has not been
registered, or if there is not a valid email address.
2.Touch [Register].
z
To cancel the settings, touch [Cancel].
TGR-318_ENG.indb 174 2017/04/06 10:44:50
To Next Page
Loading...
