Panasonic CZ-CFUNC2 - Adaptor Number; Communication Adaptor Initial Settings

ー 27 ー
Display and settings for the communication adaptor board Various procedures
■ (05) Communication adaptor initial settings
Press the UP or DOWN key to select a function from the following options.
Display Function
↑
DOWN
ＵＰ
↓
Adaptor number
Address valid
Centralised equipment main-sub
Communication adaptor number of air
conditioner linked system 1
Communication adaptor number of air
conditioner linked system 2
Chattering cancel time
Local adaptor
Initial communication at power on
(05–01) Adaptor number
•
The factory default is 0.
•
It is the address on the communication adaptor control wiring.
•
Set it in the range of 0 to 15.
[How to change]
1
Press and hold the SET key for at least 1 second and the adaptor number blinks.
2
Press the UP or DOWN key to display the adaptor number you want to set.

(Make sure not to duplicate addresses.)
3
Press and hold the SET key and when the display changes from blinking to lit, the change is
completed.
TGR-318_ENG.indb 27 2017/04/06 10:42:44