Panasonic CZ-CFUNC2 - How to Display the Microcomputer Version

ー 17 ー
Display and settings for the communication adaptor board Various procedures
6. How to display the microcomputer version
There are two ways to display the microcomputer version.
1
Restart power supply of communication adaptor board
•
Restart the power switch of the communication adaptor (if it is built in to the Intelligent Controller, restart the
switch of the Intelligent Controller).
•
The microcomputer version is displayed for 3 seconds immediately after turning on the power (refer to
“2. Display immediately after power on”) .
2
Press the HOME and DOWN keys on the communication adaptor board simultaneously.
While the two keys are pressed, the microcomputer version is displayed.
TGR-318_ENG.indb 17 2017/04/06 10:42:42