ー 29 ー
Display and settings for the communication adaptor board
Various procedures
(05–04) Communication adaptor number of air conditioner linked system 1
•
When there are two or more communication adaptors on the air conditioner linked system, set the
communication adaptor number so as to avoid address duplication.
Communication adaptor
number
Contents
0 (factory default)
1
:
7
First communication adaptor to the indoor / outdoor communication wire
Second communication adaptor to the indoor / outdoor communication wire
:
Eighth communication adaptor to the indoor / outdoor communication wire
[How to change]
1
Press and hold the SET key for at least 1 second and the communication adaptor number blinks.
2
Press the UP or DOWN key to display the value you want to set.
(Select from 0 to 7 in the table above.)
3
Press and hold the SET key and when the display changes from blinking to lit, the change is
completed.
(05–05) Communication adaptor number of air conditioner linked system 2
•
When there are two or more communication adaptors on the air conditioner link, set the communication
adaptor number so as to avoid address duplication.
Communication adaptor
number
Contents
0 (factory default)
1
:
7
First communication adaptor to the indoor / outdoor communication wire
Second communication adaptor to the indoor / outdoor communication wire
:
Eighth communication adaptor to the indoor / outdoor communication wire
[How to change]
1
Press and hold the SET key for at least 1 second and the communication adaptor number blinks.
2
Press the UP or DOWN key to display the value you want to set.
(Select from 0 to 7 in the table above.)
3
Press and hold the SET key and when the display changes from blinking to lit, the change is
completed.
TGR-318_ENG.indb 29 2017/04/06 10:42:44
To Next Page
Loading...
