Panasonic DP-8020E

375
SEP 2006
Ver. 1.0
DP-8020E/8020P/8016P
(3) Remove 10 Screws.
(4) Remove the Rear Cover.
(5) Remove the Protective Sheet.
(6) Bend the Protective Tab on the Rear Cover
approx. 180° towards the inside of the machine
as illustrated.
(7) Connect the ADF Harness to CN650 on the
SPC PC Board.
(8) Insert the Harness Clamp into a pre-drilled hole
in the frame (from underside).
Note:
Do not cut the Harness Clamp (Tie-Wrap) when
servicing. Push the release clip on the side to
remove it.
(9) Reinstall the Rear Cover.
(10) Secure the Rear Cover with 10 Screws.