10 TrueType object
characters such as “i” or “l”. This setting creates spaces of a specified value between
characters. The character spacing value is defined as the distance from the end (right
edge) of one character to the start (left edge) of the next.
(1)
(1)
Character spacing
“Fixed spacing”
Regardless of the character width, the characters are spaced evenly by a specified
value. The character spacing value is defined as the distance from the start (left edge) of
one character to the start of the next.
(1)
(1)
Character spacing
“Justify”
The space between characters is distributed evenly to align to a specified character
string width. If the specified character string width is smaller than the character width
multiplied by the number of characters, the character width is automatically reduced.
(1)
(1)
Character string width
4. Specify a value for “Character spacing [mm]” or “Character string width [mm]”.
The available setting names change depending on your selection for “Character spacing
type”.
• For “Standard” and “Fixed spacing”, input the desired value under “Character
spacing [mm]”.
• For “Justify”, input the desired value under “Character string width [mm]”.
Related topics
Set the character spacing of a TrueType object along an arc (page 115)
114 ME-NAVIS2-OP-1
To Next Page
Loading...
Need help?
General
