21 File setting
The following drawings illustrate this function.
ABC ABC
ABC
ABC
ABC
ABC
ABC
(1) (2) (3) (4)
(1)
Marking data without mirroring
(2)
“Y-axis mirroring”: Mirroring across the y-axis
(3)
“X-axis mirroring”: Mirroring across the x-axis
(4)
Mirroring across the x- and y-axis (both check boxes are selected)
Related topics
Set the laser head direction (page 264)
21.2 Specify the East Asian character set
To use East Asian characters in character objects and bar code/2D code objects, specify the
character set in the “File settings” tab.
• Go to the “Marking settings” screen and select “File settings”.
• For “East Asian characters”, select “Japanese” (default setting) or “Simplified Chinese”.
‒ Japanese and Simplified Chinese characters cannot be used together in one file.
‒ If “Japanese” is set, JIS fonts are used for the non-alphanumeric characters (file
number J1 and J2).
‒ If “Simplified Chinese” is set, GB fonts are used for the non-alphanumeric characters
(file number GB1 and GB2).
• You can change the default setting for East Asian characters under “System settings” >
“Operation/information” > “Advanced system settings” > “Default setting for East Asian
characters”.
Related topics
Configure advanced system settings (page 261)
21.3 Configure trigger parameters
Specify the trigger delay and the trigger mode settings for the trigger input TRIGGER IN of
the TERMINAL connector.
• Go to the “Marking settings” screen and select “File settings”.
224 ME-NAVIS2-OP-1
To Next Page
Loading...
Need help?
General
