15 2D code object
• “Error correction level”:
Select the level of error correction.
‒ QR Code: “L” (7%), “M” (15%), “Q” (25%) or “H” (30%).
‒ Micro QR Code: “L” (7%), “M” (15%) or “Q” (25%).
‒ iQR Code: “L” (7%), “M” (15%), “Q” (25%), “H” (30%) or “S” (50%).
• “Version”:
Specify the code version. The allowed number of input characters depends on the
selected version. If “Auto” is set, the version is selected automatically depending on the
code data.
‒ QR Code: Auto, 1–22 (Model 2), 1–14 (Model 1)
‒ Micro QR Code: Auto, M1–M4
‒ iQR Code: 1–31 (square type), R1–R15 (rectangular type)
• “Number of quiet modules”:
Specify the width of the quiet zone that surrounds the code.
Setting range: Auto (n) or 1–9. “(n)” indicates the number of modules.
If “Auto” is selected, the quiet zone width is set according to the code's requirements for
the minimum width.
‒ QR Code: The quiet zone width is set to four modules.
‒ Micro QR Code: The quiet zone width is set to two modules.
‒ iQR Code: The quiet zone width is set to one module.
• “Module height [mm]”:
Enter a numeric value to specify the height of a module.
• “Module width [mm]”:
Enter a numeric value to specify the width of a module.
• “Total width [mm]”, “Total height [mm]”:
Displays the entire width and height of the code, including the quiet zone.
Related topics
2D code types (page 155)
Structure of a QR Code (page 158)
Create a 2D code object (page 167)
QR Code Model 1 versions and data capacity (page 159)
QR Code Model 2 versions and data capacity (page 162)
Micro QR Code versions and data capacity (page 165)
Rotate a 2D code object (page 172)
Specify the position of a 2D code object (page 172)t
Set laser correction parameters for a marking object (page 238)
ME-NAVIS2-OP-1 169
To Next Page
Loading...
Need help?
General
