139
5. 4K Photo and Drive Settings
• The estimated recording ending time is displayed on the setting screen.
It is displayed under the following conditions when [Shooting Interval Setting] is set to
[OFF]:
– Recording Mode: Shutter-Priority AE Mode or Manual Exposure Mode
– Focus Mode: [MF]
• The camera may not be able to record using the pre-set interval and number of pictures to
be recorded or may not finish recording at the estimated recording ending time under
some recording conditions.
4 Press the shutter button halfway.
• The recording screen will be displayed.
5 Press the shutter button halfway to focus and then press it
fully to take the picture.
• The recording starts automatically.
• During recording standby, the camera will turn off automatically if no operation is
performed for a certain period. The Time Lapse Shot is continued even with the camera
turned off. When the recording start time arrives, the camera turns on automatically.
To turn on the camera manually, press the shutter button halfway.
• Operations during recording standby (The camera is turned on)
¢2 When you record pictures by setting [Shooting Interval Setting] to [OFF], you can
press [Fn2] even while recording is in progress. After recording (exposure) of a
picture taken at the time when you pressed [Fn2] is finished, a selection screen is
displayed.
¢3 When you record pictures by setting [Shooting Interval Setting] to [OFF], you cannot
perform touch operation.
• After the recording stops, a confirmation screen will be displayed, asking whether to
proceed to create a motion picture.
To create a motion picture, select [Yes].
For information on creating motion pictures, refer to “Motion pictures using Time Lapse
Shot/Stop Motion Animation”. (P142)
Button
operation
Touch
operation
Description of operation
[Fn2]
¢2
¢3
Displays a selection screen that lets you pause or stop
the recording.
Displays a selection screen that lets you resume or
stop the recording (during pause).
To Next Page
Loading...
Need help?
General
