71
3. Recording Modes
Program AE Mode
Recording Mode:
The camera automatically sets the shutter speed and the aperture value according to the
brightness of the subject.
You can take pictures with greater freedom by changing various settings in the [Rec]
menu.
1
Set the mode dial to [ ].
2
Press the shutter button halfway and display
the aperture value and shutter speed value
on the screen.
A Shutter speed
B Aperture value
• If the exposure is not adequate, the aperture value and shutter speed turn red and blink.
∫ Program Shift
You can change the preset aperture value and shutter speed without changing the
exposure. This is called Program Shift.
It enables you to, for example, make the background more defocused by decreasing the
aperture value or capture a moving subject more dynamically by slowing the shutter
speed.
1 Press the shutter button halfway and display the aperture value and shutter
speed value on the screen.
2 While the values are displayed (about 10 seconds),
perform Program Shift by rotating the rear dial or
front dial.
A Program Shift indication
• To cancel Program Shift, perform either of the following
operations:
– Turn off the camera.
– Rotate the front/rear dial until the Program Shift indication disappears.
Not available in these cases:
• Program Shift is not available in the following cases:
– When recording using the flash
– When recording 4K photos
– When recording with the Post Focus function
– When the ISO sensitivity is set to [ ]
0
98
98
F
3.5
60
60
F
4.0
2
00
0
98
98
To Next Page
Loading...
Need help?
General
