2. Getting Started/Basic Operations
64
Entering Text
Follow the steps below when the text entry screen is displayed.
1
Press 3/4/2/1 to select text and then
press [MENU/SET] to register.
• To repeatedly enter the same character, rotate the front/
rear dial or the control dial to the right to move the entry
location.
• Operations when the items below are selected
¢ You can also switch between text modes by pressing [DISP.].
• A maximum of 30 characters can be entered.
(Maximum of 9 characters when setting names in [Face Recog.])
• A maximum of 15 characters can be entered for [ ], [ ], [ ], [ ] and [ ].
(Maximum of 6 characters when setting names in [Face Recog.])
2
Press 3/4/2/1 to move the cursor to [Set] and then press [MENU/
SET] to end text input.
– [ ]: Switch text between [A] (upper case characters), [a] (lower case
characters), [1] (numbers), and [&] (special characters)
¢
–[]]: Enter a blank
– [Delete]: Delete a character
– [ ]: Move the entry position cursor to the left
– [ ]: Move the entry position cursor to the right
To Next Page
Loading...
Need help?
General
