306
12. Others
Optional accessories
• Some optional accessories may not be available in some countries.
After attaching the flash (DMW-FL580L, DMW-FL360L,
DMW-FL200L: optional), the effective range will be increased when
compared to the camera’s built-in flash.
Preparations:
• Close the built-in flash and set the camera on/off switch to [OFF].
• To change the settings for external flashes on the camera, refer to P161.
• Refer to P166 about the settings for the wireless flash.
External Flash (optional)
Removing the Hot Shoe Cover
The camera comes with a hot shoe cover attached to the hot
shoe.
Remove the hot shoe cover by pulling it in the direction
indicated by arrow
2
while pressing it in the direction
indicated by arrow
1
.
• Keep the Hot Shoe Cover out of reach of children to prevent
swallowing.
When using other commercially available external flashes without
communication functions with the camera
• It is necessary to set the exposure on the external flash. If you want to use the external flash
in Auto Mode, use an external flash that allows you to set the aperture value and the ISO
sensitivity to match the settings on the camera.
• Set to Aperture-Priority AE Mode or Manual Exposure Mode on the camera and then set the
same aperture value and ISO sensitivity on the external flash. (The exposure cannot be
compensated adequately due to the change on the aperture value in Shutter-Priority AE
Mode and the external flash cannot control the light adequately in Program AE Mode
because the aperture value cannot be fixed.)
To Next Page
Loading...
Need help?
General
