119
5. 4K Photo and Drive Settings
Taking Pictures using Burst Mode
Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
1
Set the drive mode dial to [ ].
2
Select the Burst Mode setting.
Settings: [H] (High speed), [M] (Middle speed), [L]
(Low speed)
3
Focus on the subject and take a picture.
• Hold down the shutter button fully to activate the Burst Mode.
∫ Burst Rate
∫ Number of burst picture frames
• When recording is performed under the test conditions specified by Panasonic.
The burst speed will become slower halfway. However, pictures can be taken until the capacity
of the card becomes full.
Depending on recording conditions, the number of burst pictures that can be taken will be
reduced.
> [Rec] > [Burst Rate]
Burst Rate Live View during Burst Mode
[H] (High speed)
9 frames/second ([AFS]/[MF])
6 frames/second ([AFF]/[AFC])
None ([AFS]/[MF])
Available ([AFF]/[AFC])
[M] (Middle speed) 6 frames/second Available
[L] (Low speed) 2 frames/second Available
With RAW files Without RAW files
[H] (High speed)
30 frames or more 600 frames or more
[M] (Middle speed)
[L] (Low speed)
To Next Page
Loading...
Need help?
General
