159
6. Stabilizer, Zoom and Flash
Using a Flash
Applicable modes:
∫ Open/Close the built-in flash
A To open the flash
Slide the flash open lever.
• Be careful when opening the flash as the flash will jump
out.
B To close the flash
Press the flash until it clicks.
• Be careful not to catch your finger, etc.
• Forcibly closing the flash can damage the camera.
• Be sure to close the built-in flash when not in use.
∫ The available flash range (approximation)
When you use certain lenses, light from the flash may be blocked or fail to cover the
lens field of view, causing dark areas to appear in the resulting pictures.
The distance at which light from the flash is blocked by lens, and the distance to which
light from the flash is delivered vary depending on the lens used. Check the distance to the
subject when taking a picture.
• These ranges are obtained when the ISO sensitivity is set to [AUTO] and [ISO Auto Upper Limit
Setting] in [ISO Sensitivity (photo)] is set to [AUTO].
When the interchangeable lens (H-FS12060) is used
Wide Tele
0.5 m (1.6 feet) to 7.3 m (24 feet) 0.3 m (0.98 feet) to 4.5 m (15 feet)
When the interchangeable lens (H-FSA14140) is used
Wide Tele
0.5 m (1.6 feet) to 7.3 m (24 feet) 0.5 m (1.6 feet) to 4.5 m (15 feet)
When the interchangeable lens (H-FS1442A) is used
Wide Tele
0.5 m (1.6 feet) to 7.3 m (24 feet) 0.3 m (0.98 feet) to 4.5 m (15 feet)
To Next Page
Loading...
Need help?
General
