273
10. Using the Wi-Fi/Bluetooth function
The smartphone sends its location information to the camera via Bluetooth, and the
camera performs recording while writing the acquired location information.
Preparations:
Enable the GPS function on the smartphone.
1 Make a Bluetooth connection to the smartphone. (P260)
2 Select the camera’s menu.
• The camera will enter a mode where location information can be recorded and [ ] will
be displayed on the recording screen.
3 Take pictures on the camera.
• Location information will be written to the recorded pictures.
Recording location information
Wireless connectivity required:
A The smartphone acquires
location information.
B The smartphone sends the
location information.
C The camera performs recording
while writing the location
information.
> [Setup] > [Bluetooth] > [Location Logging] > [ON]
When [ ] appears translucent
Location information is not acquired, so data cannot be written. Positioning with the GPS on the
smartphone may not be possible if the smartphone is in a location such as a building or a bag.
• Move the smartphone to a location where positioning performance can be optimized, such as
one that offers a wide view of the sky, to try positioning.
• Refer to the operating instructions of your smartphone.
• Images with location information are indicated with [ ].
• The smartphone drains its battery faster while acquiring location information.
• Be sure to pay special attention to the privacy, the likeness rights, etc. of the subject
when you use this function. Use at your own risk.
Not available in these cases:
• Location information is not written to AVCHD motion pictures.
MENU
To Next Page
Loading...
Need help?
General
