11. Connecting to other devices
300
Preparations:
Install “PHOTOfunSTUDIO” on PC. (P298)
1 Turn on the camera and the PC, and then connect these with the USB
connection cable (supplied).
• Check the direction of the terminals and plug in/out straight holding onto the plug.
(It may result in malfunction by the deforming of the terminal if it is plugged in obliquely or
in wrong direction.)
Do not connect devices to incorrect terminals. Doing so may cause malfunction.
• Do not use any other USB connection cables except the supplied one.
A [USB/CHARGE] socket
B USB connection cable (supplied)
2 Press 3/4 to select [PC(Storage)], and then press [MENU/SET].
• If [USB Mode] is set to [PC(Storage)] in the [Setup] menu in advance, the camera will be
automatically connected to the PC without displaying the [USB Mode] selection screen.
• A message about charging may be displayed. Wait until the display disappears.
3 Copy the images to a PC using “PHOTOfunSTUDIO”.
• Do not delete or move copied files or folders in Windows Explorer.
When viewing in “PHOTOfunSTUDIO”, you will not be able to play back or edit.
Copying images to a PC
• Before removing or inserting the card, turn off the camera and disconnect the USB connection
cable. Otherwise, damage may be caused to the recorded data.
• Use a sufficiently charged battery, or the AC adaptor (optional) and the DC coupler (optional).
• If the remaining battery power becomes low while the camera and the PC are communicating,
the alarm beeps.
Disconnect the USB connection cable safely. Otherwise, damage may be caused to the
recorded data.
To Next Page
Loading...
Need help?
General
