167
6. Stabilizer, Zoom and Flash
2
Select the menu.
3
Press 3/4 to select an item and then
press [MENU/SET].
• To fire a test flash, press [DISP.].
A Flash output
B Luminosity ratio
C Firing Mode
¢1 Not available when [Wireless FP] is set to [ON].
¢2 This option is not displayed when the flash (DMW-FL200L: optional) is attached to the
camera.
¢3 Available when an external flash is attached.
> [Rec] > [Flash]
[Wireless]
Select [ON].
The flash icon on the screen will be indicated with [WL].
[Wireless Channel]
Select the channel you have set for the wireless flashes in
step
1.
[Wireless Setup] Proceed to step 3.
[Built-in
Flash]
¢1
/
[External
Flash]
¢1
[Firing
Mode]
[TTL]: The camera automatically sets the output.
[AUTO]
¢2, 3
: Flash output is set by the external flash.
[MANUAL]
¢3
: Set the luminosity ratio of the external flash
manually.
[OFF]: The flash on the camera side emits only
communication light.
[Flash
Adjust.]
Set the flash output of the camera manually when [Firing Mode] is
set to [TTL].
[Manual
Flash
Adjust.]
Set the luminosity ratio of the external flash when [Firing Mode] is
set to [MANUAL].
• You can set from [1/1] (full brightness) to [1/128] in steps of 1/3.
[A Group]/
[B Group]/
[C Group]
[Firing
Mode]
[TTL]: The camera automatically sets the output.
[AUTO]
¢1
: The wireless flashes automatically set the output.
[MANUAL]: Set the luminosity ratio of the wireless flashes
manually.
[OFF]: The wireless flashes of the specified group will
not fire.
[Flash
Adjust.]
Adjust the output of the wireless flashes manually when [Firing
Mode] is set to [TTL].
[Manual
Flash
Adjust.]
Set the luminosity ratio of the wireless flashes when [Firing Mode]
is set to [MANUAL].
• You can set from [1/1] (full brightness) to [1/128] in steps of 1/3.
To Next Page
Loading...
