23
2. Getting Started/Basic Operations
∫ Removing the Battery
Push the lever A in the direction of the arrow to remove.
• Confirm that there is no foreign matter adhered on the inner side (rubber seal) of the battery
door.
• Remove the battery after use.
(The battery will be exhausted if left for a long period of time after being charged.)
• The battery becomes warm after using it and during and after charging. The camera
also becomes warm during use. This is not a malfunction.
• Turn the camera off and wait for the “LUMIX” display on the monitor to clear before removing
the battery.
(Otherwise, this unit may no longer operate normally and the card itself may be damaged or
the recorded pictures may be lost.)
• Be careful when removing the battery as the battery will jump out.
To Next Page
Loading...
Need help?
General
