237
9. Menu Guide
The following network settings are reset to the default:
–[Wi-Fi Setup]
– Registered device information in [Bluetooth] and values in [Wi-Fi network settings]
It will perform optimization of imaging device and image processing.
Dust reduction to blow off the debris and dust that have affixed to the front of the imaging
device is performed.
You can try Post Focus operations, such as focusing and Peaking, with the image picture.
Displays the certification number for radio regulations.
[Reset Network Settings]
• When requesting a repair or transferring/disposing of the camera, refer to “About the personal
information” on P334.
[Pixel Refresh]
• Imaging device and image processing is optimized when the camera is purchased. Use this
function when bright spots that do not exist in the subject get recorded.
• Turn the camera off and on after the pixels are corrected.
[Sensor Cleaning]
• The dust reduction function will operate automatically if you set the camera on/off switch to
[ON]. Use this function if the dust is particularly noticeable.
[Level Gauge Adjust.]
[Adjust.]
Hold the camera in a horizontal position, and press [MENU/SET]. The
level gauge will be adjusted.
[Level Gauge
Value Reset]
Restores the default level gauge setting.
[Demo Mode]
[Approved Regulations]
To Next Page
Loading...
Need help?
General
