261
10. Using the Wi-Fi/Bluetooth function
7 Start “ Image App”.
• The paired smartphone will be registered as a paired device after connected via Wi-Fi.
∫ Connecting to a Paired Smartphone
1 Start “Image App” and then select [Bluetooth].
• If a message is displayed indicating that the smartphone is searching for cameras, close
the message.
2 Turn on the Bluetooth.
3 Select the camera (device name) you want to connect to from the [Camera
registered] list.
• Even if you set up pairing with more than one smartphone, you can only connect to one
smartphone at a time.
∫ End Bluetooth Connection
• The connection will be terminated and the camera’s Bluetooth function will be deactivated.
• Even if you terminate the connection, the pairing information for it will not be deleted.
∫ Canceling Pairing
1 Select the menu.
2 Select the smartphone you want to delete.
Select the camera (device name) for which to delete the pairing information from the [Camera
registered] list.
On the camera
> [Setup] > [Bluetooth] > [Bluetooth] > [ON]
On your smartphone
> [Setup] > [Bluetooth] > [Bluetooth] > [OFF]
On the camera
> [Setup] > [Bluetooth] > [Bluetooth] > [SET] > [Delete]
On your smartphone
• [ ] is displayed on the recording screen during Bluetooth connection. When the Bluetooth
function is enabled, but a connection is not established, [ ] appears translucent.
• When it takes time to set up pairing between a smartphone and a camera, delete the pairing
information of both devices and register them again. This may enable the devices to be
recognized properly.
• Up to 16 smartphones can be registered. If you try to register more than 16 devices, the
smartphone with the oldest registration history will be replaced.
• Performing [Reset Network Settings] will delete registered device information.
MENU
To Next Page
Loading...
Need help?
General
