Panasonic LUMIX DC-G95D

2. Getting Started/Basic Operations
46
∫ Setting the functions to be assigned to 3/4 and dials in the exposure
compensation screen
Temporarily changing the items assigned to the front/rear dials
([Dial Operation Switch])
1 Set a Fn button to [Dial Operation Switch]. (P60)
• This function is set in the Fn button (Fn1) at the time of purchase.
2 Press the Fn button.
• A guide will be displayed showing the items temporarily
assigned to the front/rear dials.
• If no operations are performed, the guide will disappear in
a few seconds.
3 Rotate the front/rear dials while the guide is
displayed.
4 Press [MENU/SET] and set.
• You can also complete this step by performing either of the operations below:
– Press the shutter button halfway
– Press the Fn button
> [Custom] > [Operation] > [Exposure Comp. Disp. Setting]
[Cursor Buttons (Up/Down)]
[] [Exposure Bracket]
[OFF] [OFF]
[Front/Rear Dials]
[/] [Exposure Comp.]/[Exposure Comp.]
[/][Flash Adjust.]/[Exposure Comp.]
[OFF/ ] [OFF]/[Exposure Comp.]
[/ ][Exposure Comp.]/[Flash Adjust.]
[ /OFF] [Exposure Comp.]/[OFF]
• You can set the following settings in [Dial Set.] of the [Custom] ([Operation]) menu. (P48)
– Operation methods of the front/rear dials
– Operation method of the control dial
– Items to be assigned temporarily to the front/rear dials in [Dial Operation Switch]
MENU
989898
0
ISOISOISOISO
WBWBWBWB
WB
WBWBWB
WBWBWBWBWBWBWB
AWBc
AWBc
AWBw
AWBw
AWB
AWB
ISOISOISOISO