Panasonic PT-REQ15 - [Backup Input Setting]

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 123
Note
f The movable range and shape of the screen marker may be a󰀨ected due to correction of distortion of the projected image in [GEOMETRY].
f The screen marker is not displayed in the preview window of the web control.
[LINE MARKER]
1) Press qw to select [LINE MARKER].
f The green outer border (xed) and the red markers at the vicinity of each edge at top, bottom, left, and right
are displayed.
2) Press the <ENTER> button.
f The [LINE MARKER] screen is displayed.
3) Press as to select [UPPER], [LOWER], [LEFT], or [RIGHT].
4) Press qw to adjust the position of the red marker.
Note
f The red marker is not displayed in [LINE MARKER] screen when the marker position is [0].
f [LINE MARKER] cannot be selected or adjusted in following cases.
g When [ADVANCED MENU] menu → [EDGE BLENDING] is set to anything other than [OFF]
[CROSSHAIR MARKER]
1) Press qw to select [CROSSHAIR MARKER].
f The crosshair marker is displayed.
2) Press the <ENTER> button.
f The [CROSSHAIR MARKER] screen is displayed.
3) Press asqw to adjust the position of the crosshair marker.
f Press asqw to make ne adjustments. The adjustment can be performed faster by holding down the
button.
f The values shown in [VERTICAL] and [HORIZONTAL] are the coordinates of the center of the crosshair
marker and vary according to the position of the crosshair marker.
Note
f The position of the crosshair marker can also be specied using the number buttons on the remote control.
f To move the crosshair marker to the center of the screen, press the <DEFAULT> button on the remote control.
f [CROSSHAIR MARKER] cannot be selected or adjusted in following cases. In addition, if the following operation is performed while
[CROSSHAIR MARKER] is selected, the [SCREEN MARKER] setting will automatically switch to [OFF] and the crosshair marker will no
longer be displayed.
g When the [POSITION] menu → [GEOMETRY] is set to anything other than [OFF] → [FREE GRID] is set to [ON] → the grid lines are
displayed after the <ENTER> button is pressed
g For Geometric & Setup Management Software application, [Grid Resolution] → [Display Grid Lines] is set to anything other than [OFF]
and the grid lines are displayed.
f Custom masking cannot be displayed while the crosshair position is being adjusted. If the crosshair marker position adjustment screen is
displayed while custom masking is being displayed, the custom masking will temporarily hidden but will reappear when the crosshair marker
position adjustment screen is exited.
f Waveform monitor display is disabled while the crosshair marker is displayed. If the crosshair marker is displayed during waveform monitor
display, the waveform monitor will be non-displayed.
[BACKUP INPUT SETTING]
Set the backup function that switches the signal to the backup input signal as seamless as possible when input
signal is disrupted.
1) Press as to select [BACKUP INPUT SETTING].
2) Press the <ENTER> button.
f The [BACKUP INPUT SETTING] screen is displayed.
3) Press as to select [BACKUP INPUT MODE].
4) Press the <ENTER> button.
f The [BACKUP INPUT MODE] screen is displayed.