Panasonic PT-REQ15 - [Menu Mode]; [Back Color]

Chapter 4 Settings — [DISPLAY OPTION] menu
142 - ENGLISH
3) Press as to select [INPUT GUIDE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
Displays the input guide.
[OFF]
Hides the input guide.
Note
f [MEMORY NO.] will not be displayed when the [PROJECTOR SETUP] menu → [STORE TYPE] is set to [SHARED].
Setting [WARNING MESSAGE]
Set the display/hide of the warning message.
1) Press as to select [ON-SCREEN DISPLAY].
2) Press the <ENTER> button.
f The [ON-SCREEN DISPLAY] screen is displayed.
3) Press as to select [WARNING MESSAGE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
Displays the warning message.
[OFF]
Hides the warning message.
Note
f If [OFF] is set, the warning message will not be displayed on the projected image even when warning condition such as [TEMPERATURE
WARNING] is detected while using the projector. Also, the following countdown message is not displayed: the message until the power
is turned o󰀨 after the no signal shut‑o󰀨 function is executed; the message until the light source is turned o󰀨 after the no signal lights‑out
function is executed
[MENU MODE]
Set the display mode of the menu screen (OSD).
1) Press as to select [MENU MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
Displays all menu items.
[SIMPLE]
Displays some of the menu items that are used for basic setting or adjustment.
Note
f For the menu items that are displayed when [SIMPLE] is set, refer to “Main menu” (x page 90), “Sub-menu” (x page 91).
[BACK COLOR]
Set the display of the projection screen when a signal is not input.
1) Press as to select [BACK COLOR] and press the <ENTER> button.
f The [BACK COLOR] screen is displayed.
2) Press as to select the item.
f Select the image you want to display.
[BLUE]
Displays blue in the entire projection screen.
[BLACK]
Displays black in the entire projection screen.
[DEFAULT LOGO]
Displays the Panasonic logo in the projection screen.
[USER IMAGE 1]
Displays the image registered by the user in the projection screen.
If no user image is registered, [NO IMAGE] is displayed. You can register the user image following the
instructions displayed on the screen by selecting [NO IMAGE] and pressing the <ENTER> button.
For details on registering an image, refer to “Registering the user image” (x page 183).
[USER IMAGE 2]
[USER IMAGE 3]
[USER IMAGE 4]