Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 177
[STORE TYPE]
Set whether the image adjustment data is treated as common regardless of the signal format, or whether the data
is stored for each signal format.
1) Press as to select [STORE TYPE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[SHARED]
The image adjustment data is treated as common regardless of the signal format.
For example, data adjusted for one particular input signal is applied to other input signals.
[SEPARATE]
Performs image adjustment for each individual input signal and maintains the corresponding image
adjustment data for each as before.
Note
f The subject image adjustment data are as follows.
g The [PICTURE] menu items (excluding [DEFAULT PICTURE MODE])
g The [POSITION] menu items (excluding [GEOMETRY])
g The [ADVANCED MENU] menu items
f While displaying the menu screen of the above items, you can set [STORE TYPE] on the [OPTION] screen displayed by pressing the
<INPUT MENU> button on the remote control or control panel.
f When [STORE TYPE] is set to [SHARED], the following menu items cannot be set.
g The [PICTURE] menu → [DEFAULT PICTURE MODE]
g The [SIGNAL LIST] menu
f When [STORE TYPE] is set to [SHARED], the displayed adjustment range of the following menu may exceed the actual control range
depending on the input signal. In this case, the adjustment value that exceeds the actual control range becomes invalid and the adjustment
state is at the upper limit or lower limit of the control range.
g The [ADVANCED MENU] menu → [BLANKING] / [FRAME RESPONSE] / [RASTER POSITION]
[USB CONNECT CONTROL]
Set whether to allow access to the projector from a smartphone or tablet device using the USB CONNECT
CONTROL function.
USB CONNECT CONTROL is a function that allows a device to access the web control screen of the projector
using the USB tethering function of the device.
1) Press as to select [USB CONNECT CONTROL].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
Enables the USB CONNECT CONTROL function.
[DISABLE]
Disables the USB CONNECT CONTROL function.
Note
f To access the projector, the application software "Smart Projector Control" for setting up and adjusting the projector must be installed on the
device.
f The setting of [USB CONNECT CONTROL] is only available for the application software "Smart Projector Control" version 3.0.0 or later.
f After connecting the device to the <USB> terminal of the projector via a USB cable or a Lightning to USB cable, enable the USB tethering
function on the device (or the "Personal Hotspot" function on the iPhone).
f For details of the “Smart Projector Control”, visit the following website.
https://panasonic.net/cns/projector/
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
Disables the <FUNCTION> button.
[FREEZE]
Temporarily pauses the image. (x page 146)
To Next Page
Loading...
