Panasonic PT-REQ15 - [Initial Startup]; [Startup Input Select]; [Date and Time]

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 169
Note
f The [NO SIGNAL SHUT-OFF] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [POWER MANAGEMENT] → [NO SIGNAL SHUT-OFF]
[INITIAL STARTUP]
Set the startup method when the <MAIN POWER> switch is set to <ON>.
1) Press as to select [INITIAL STARTUP].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY]
Starts up the projector in the condition before the <MAIN POWER> switch is set to <OFF>.
[STANDBY]
Starts up the projector in standby.
[ON]
Starts projecting immediately.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1) Press as to select [STARTUP INPUT SELECT].
2) Press the <ENTER> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3) Press asqw to select the input, and press the <ENTER> button.
[LAST USED]
Keeps the input selected last.
[HDMI1]
Sets the input to HDMI1.
[HDMI2]
Sets the input to HDMI2.
[DisplayPort]
Sets the input to DisplayPort.
[SDI [SLOT]]
*1
Sets the input to SDI.
[SDI OPT1 [SLOT]]
*2
Sets the input to SDI OPT1.
[SDI OPT2 [SLOT]]
*2
Sets the input to SDI OPT2.
[DIGITAL LINK [SLOT]]
*3
Sets the input to DIGITAL LINK.
[PressIT [SLOT]]
*4
Sets the input to PressIT.
[SLOT]
*5
Sets the input to SLOT.
[INPUT1] - [INPUT10]
*3 *6
Sets the input to DIGITAL LINK, and switches the input of the DIGITAL LINK output supported device
to the specied input.
*1 This item can be selected when the optional 12G-SDI Terminal Board (Model No.: TY-SB01QS) is installed in <SLOT>.
*2 This item can be selected when the optional Function Board for 12G-SDI Optical (Model No.: TY-SB01FB) is installed in <SLOT>.
*3 This item can be selected when the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is installed in <SLOT>.
*4 This item can be selected when the optional Wireless Presentation System Receiver Board (Model No.: TY-SB01WP) is installed in <SLOT>.
*5 This item can be selected when the Function Board by other manufacturers is installed in <SLOT>.
*6 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK IN/
LAN> terminal of the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) installed in <SLOT>, its input name is automatically
reected from [INPUT1] to [INPUT10]. When an item that does not reect the input name is selected, it will be disabled.
[DATE AND TIME]
Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
3) Press as to select [TIME ZONE].
4) Press qw to switch [TIME ZONE].