Chapter 4 Settings — [PROJECTOR SETUP] menu
168 - ENGLISH
[DEFAULT LOGO]
Displays the Panasonic logo in the projection screen.
[USER IMAGE 1]
Displays the image registered by the user in the projection screen.
If no user image is registered, [NO IMAGE] is displayed. You can register the user image following the
instructions displayed on the screen by selecting [NO IMAGE] and pressing the <ENTER> button.
For details on registering an image, refer to “Registering the user image” (x page 183).
[USER IMAGE 2]
[USER IMAGE 3]
[USER IMAGE 4]
6) Press the <ENTER> button.
Note
f You can also switch the [BACK COLOR] item by pressing the qw button while the [BACK COLOR] menu is selected.
f The [BACK COLOR] setting item is common with the following menu item.
g The [DISPLAY OPTION] menu → [BACK COLOR]
f For the procedure to set the back color from the web control screen, refer to [Back color] (x page 244).
[NO SIGNAL LIGHTS-OUT]
This is a function to automatically turn o the light source of the projector when there is no input signal for specic
period. The time until the light source is turned o can be set.
1) Press as to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3) Press as to select [NO SIGNAL LIGHTS-OUT].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
Disables the no signal lights-out function.
[10SEC.] - [5MIN.]
Turns o the light source when there is no input signal for the preset period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or [5MIN.].
Note
f The [NO SIGNAL LIGHTS-OUT] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [POWER MANAGEMENT] → [NO SIGNAL LIGHTS-OUT]
f The fan will rotate to cool the projector while the no signal lights‑out function is operating and the light source is turned o. Also, the power
indicator <ON (G)/STANDBY (R)> blink green slowly.
f When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the following are the conditions to turn the light source back on
again from the condition that the light source has turned o by this function.
g When the signal is input
g When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
g When the <POWER ON> button is pressed
g When the operation to disable the shutter function (shutter: opened) is performed, such as pressing the <SHUTTER> button
g When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
f The no signal lights-out function is disabled in following cases.
g When [BACK COLOR] is set to other than [BLUE] and [BLACK], and the Panasonic logo or the image registered by the user is displayed
in the projected image
[NO SIGNAL SHUT-OFF]
A function that automatically switches the power source of the projector to standby if there is no input signal for a
certain period of time. The time before switching to standby can be set.
1) Press as to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3) Press as to select [NO SIGNAL SHUT-OFF].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
Disables the No signal shut‑o function.
[10MIN.] - [90MIN.]
Sets the time in increments of 10 minutes.
To Next Page
Loading...
