Panasonic PT-REQ15 - [Indicator Setting]

Chapter 4 Settings — [PROJECTOR SETUP] menu
182 - ENGLISH
2) Press the <ENTER> button or the <DEFAULT> button.
f The angle benchmark will switch each time you press the button.
<ENTER> button Displays the angle of the zero calibration state representing the current installation attitude of the projector
<DEFAULT> button
Displays the angle of the zero calibration reset state.
Resets the zero calibration and displays the detection result of the angle sensor as it is.
Note
f The illustration of the projector in the [ANGLE MONITOR] screen does not rotate and does not follow the attitude change of the projector.
f The illustration of the projector shows the monitor of the roll angle and the monitor of the pitch angle.
g The rear view illustration of the projector(left side): indicates the roll angle
g The side view illustration of the projector(right side): indicates the pitch angle
f The green line intersecting the illustration of the projector indicates the angle to the benchmark selected in step 2). Read the left and right
gauges.
f The red wq mark on the horizontal axis represents the benchmark surface (0°, +180°) selected in step 2).
f The values shown at the top of of the roll angle monitor and the pitch angle monitor are common with the values displayed in [ROLL ANGLE]
and [PITCH ANGLE] on the [STATUS] screen.
f The benchmark selected in step 2) remains unchanged even if the main power is turned o󰀨 and on.
f [ANGLE MONITOR] screen can be displayed directly by pressing the <FUNCTION> button when [PROJECTOR SETUP] menu →
[FUNCTION BUTTON] is set to [ANGLE MONITOR].
[INDICATOR SETTING]
Set the indicator‑o󰀨 function that allows the projector can be used without the indicators (power indicator <ON (G)/
STANDBY (R)>, light source indicator <LIGHT1> / <LIGHT2>, temperature indicator <TEMP>) lit or blink even
when the projector is in standby mode or projection mode.
1) Press as to select [INDICATOR SETTING].
2) Press the <ENTER> button.
f The warning message of the indicator‑o󰀨 function is displayed.
3) Press the <ENTER> button.
f The [INDICATOR SETTING] screen is displayed.
4) Press as to select [INDICATOR MODE].
5) Press qw to switch the item.
[NORMAL]
Disables the indicator‑o󰀨 function.
Each indicator lits or blinks depending on the status of the projector.
[OFF]
Enables the indicator‑o󰀨 function.
Keep all the indicators o󰀨 regardless of the status of the projector.
[TIMEOUT]
Automatically enables the indicator‑o󰀨 function to turn o󰀨 all the indicators if no operation is performed for the
preset time.
f Proceed to Step 6) when [TIMEOUT] is selected.
f Proceed to Step 8) when [OFF] is selected.
6) Press as to select [NO ACTIVITY TIME].
7) Press qw to switch the item.
f The items will switch each time you press the button.
[1 MIN.] - [15 MIN.]
Sets the time until the the indicator‑o󰀨 function is enabled.
Allows you to set in increments of 1 minute. (Factory default setting: [15 MIN.])
8) Press as to select [NOTIFICATION].
9) Press qw to switch the item.
[ENABLE]
The light source indicator <LIGHT1> / <LIGHT2> and the temperature indicator <TEMP> will lit or blink
immediately when there is an occurrence of error/warning in the projector even if the indicator‑o󰀨 function is
enabled, .
[DISABLE]
The indicators will not lit or blink to inform the occurrence of error/warning when the indicator‑o󰀨 function is
enabled.