Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 183
Note
f If any button on the remote control or on the control panel is pressed within the preset time in [NO ACTIVITY TIME] , the [TIMEOUT] setting
does not function and the indicators do not lit or blink even the time set in [NO ACTIVITY TIME] has elapsed.
f In following cases, the indicators will temporarily lit or blink for operation check even if the indicator‑o function is enabled.
g right after pressing the <ON> side of the <MAIN POWER> switch to turn on the power
[USER IMAGE]
Register your favorite image to the projector to use it as a back color (x page 142), a startup logo (x page 143)
or a test pattern (x page 190).
Image les available for registration
The image le that can be registered in the projector is a still image data fullling following conditions.
Extension Format Limitation
.jpg/.jpeg/.jpe JPEG
Number of pixels:
Minimum 192 x 120
Maximum 3 840 x 2 400 (For PT-REQ15)
1 920 x 1 200 (For PT-REZ15)
(The number of pixels in height and width must be the multiple of 8.)
File format: supports baseline only
YUV format: supports YUV444, YUV422 (horizontal downsampling) and YUV420
Color mode: RGB only
.bmp Windows Bitmap
Number of pixels:
Maximum 3 840 x 2 400 (For PT-REQ15)
1 920 x 1 200 (For PT-REZ15)
1/8/24 bits
.png PNG
Number of pixels:
Maximum 3 840 x 2 400 (For PT-REQ15)
1 920 x 1 200 (For PT-REZ15)
1/8/16/24/32/48/64 bits
(However, α blending becomes invalid and the background image will not be transparent.)
Registering the user image
1) Save the image file to be registered to the projector on a USB memory.
2) Insert the USB memory into the <USB> terminal.
3) Press as to select [USER IMAGE], and press the <ENTER> button.
f The [USER IMAGE] screen is displayed.
4) Press as to select [NO IMAGE] or [USER IMAGE 1] / [USER IMAGE 2] / [USER IMAGE 3] / [USER
IMAGE 4], and press the <ENTER> button.
f The [USER IMAGE] screen is displayed.
5) Press as to select [SAVE USER IMAGE], and press the <ENTER> button.
f The [SAVE USER IMAGE] screen is displayed.
f Proceed to Step 7) if the le for image to register is saved in the root directory of the USB memory.
6) Press as to select the folder in which the file is saved, and press the <ENTER> button.
f Repeat the folder selection operation until the le for the image to register is displayed.
7) Press as to select the file, and press the <ENTER> button.
f The conrmation screen is displayed.
8) Press qw to select [OK], and press the <ENTER> button.
f The registration is completed.
Note
f For the USB memory that can be used with the projector and handling of the memory, refer to “Using the USB memory” (x page 84).
f When the projector is initialized by one of the following methods, the image registered in [USER IMAGE] will be deleted.
g When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER IMAGE ONLY]
g When initialized by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [USER IMAGE] to [INITIALIZE]
To Next Page
Loading...
