Chapter 4 Settings — [SECURITY] menu
ENGLISH - 197
8) Press qw to switch the item.
[ENABLE] Enables button operations.
[DISABLE] Disables button operations.
f When [INPUT SELECT BUTTON] is selected in Step 7), the item that can be set varies depending on the
selected button.
Refer to “Item that can be set with [INPUT SELECT BUTTON]” (x
page 197) for details.
Once the switching of the item is completed, press the <MENU> button to return to the [CONTROL PANEL]
screen or the [REMOTE CONTROL] screen.
9) Press as to select [APPLY], and press the <ENTER> button.
f The conrmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f When a button operation is performed on the device set to [DISABLE], the [CONTROL DEVICE PASSWORD] screen is displayed.
Enter the control device password.
f The [CONTROL DEVICE PASSWORD] screen will disappear when there is no operation for approximately 10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned o (cannot
enter standby).
f When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main
menu.
f Even when button operations on the remote control are disabled, the operation of the <ID SET> button and <ID ALL> button on the remote
control is enabled.
Item that can be set with [INPUT SELECT BUTTON]
When [INPUT SELECT BUTTON] is selected in Step 7) of “Enabling/disabling any button” (x
page 196), the
item that can be selected varies depending on the button to set.
The item that can be selected when each button is set is as follows.
r [HDMI1/2 BUTTON]
[TOGGLE]
Switches the items in following order when the button is operated.
[HDMI1] → [HDMI2]
[HDMI1] Fixes to selection operation of the HDMI1 input.
[HDMI2] Fixes to selection operation of the HDMI2 input.
[DISABLE] Disables button operations.
r [SLOT BUTTON]
[TOGGLE], [SDI OPT1 [SLOT]] and [SDI OPT2 [SLOT]] can be selected when the optional Function Board for
12G-SDI Optical (Model No.: TY-SB01FB) is installed in <SLOT>.
[TOGGLE]
Switches the items in following order when the button is operated.
[SDI OPT1 [SLOT]] → [SDI OPT2 [SLOT]]
[SDI OPT1 [SLOT]] Fixes to selection operation of the SDI OPT1 input.
[SDI OPT2 [SLOT]] Fixes to selection operation of the SDI OPT2 input.
[DISABLE] Disables button operations.
Note
f [SLOT BUTTON] can be selected when the Function Board is installed in the slot.
[CONTROL DEVICE PASSWORD CHANGE]
The control device password can be changed.
1) Press as to select [CONTROL DEVICE PASSWORD CHANGE].
2) Press the <ENTER> button.
f The [CONTROL DEVICE PASSWORD CHANGE] screen is displayed.
3) Press asqw to select the text, and press the <ENTER> button to enter the text.
To Next Page
Loading...
