EasyManua.ls Logo

Panasonic PT-REQ15 - Page 295

Panasonic PT-REQ15
316 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 7Appendix — Specications
ENGLISH - 295
Acoustic noise
*1
42 dB
when [OPERATING MODE] is set to [NORMAL] or
[ECO]
38 dB when [OPERATING MODE] is set to [QUIET]
Operating
environment
Operating temperature
0 °C (32 °F) to 45 °C (113 °F)
*2*3*4
Operating humidity
10 % to 80 % (no condensation)
Operation position
[FLOOR/CEILING], [FRONT/REAR]
Power requirements
100 V - 240 V ~ (100 V - 240 V alternating current), 50 Hz/60 Hz
Rated current
11.5 A - 4.7 A
Maximum power consumption
PT-REQ15, PT-REQ15L
1 140 W
PT-REZ15, PT-REZ15L
1 090 W
Standby mode power consumption
Approx. 12 W
When [STANDBY MODE] is set to [NORMAL]
f [QUICK STARTUP] function is disabled
f no Function Board attatched
f <DC OUT> terminal is not in use
Approx. 0.5 W when [STANDBY MODE] is set to [ECO]
Standard outside
dimensions
Width
498 mm (19-19/32") (excluding protrusions)
Height
212 mm (8-11/32") (with the feet at shortest position)
196 mm (7-23/32") (excluding the feet and protrusions)
Depth
PT-REQ15, PT-REZ15
648 mm (25-1/2") (excluding protrusions, including
standard zoom lens)
PT-REQ15L, PT-REZ15L
538 mm (21-3/16") (excluding protrusions and optional
lens)
Weight
*5
PT-REQ15, PT-REZ15
Approx. 28.7 k] (63.3 lbs.) (including standard zoom
lens)
PT-REQ15L, PT-REZ15L
Approx. 27.0 k] (59.5 lbs.) (excluding the optional lens)
Outer case
Materials
Molded plastic
Color
Black
Power cord length
3.0 m (118-1/8")
Laser
Classication
Laser Class
Class 1 (IEC 60825-1:2014)
Risk Group
Risk group 3 (IEC 62471-5:2015)
Wireless LAN
*6
Compliance standards
IEEE802.11b/g/n
Transmission method
DSSS, OFDM
Frequency range
(Channel)
2 412 MHz to 2 462 MHz (1 to 11ch)
Data transfer speed
(Standard value)
IEEE802.11n Maximum 144 Mbps
IEEE802.11g Maximum 54 Mbps
IEEE802.11b Maximum 11 Mbps
Encryption method
WPA2-PSK (AES)
Remote control
Power requirements
DC 3 V (AAA/R03/LR03 battery x 2)
Operating range
Within approx. 30 m (98'5") (when operated directly in front of signal receiver)
Weight
102 ] (3.6 ozs.) (including batteries)
Outside dimensions
Width: 48 mm (1-7/8"), Height: 145 mm (5-23/32"), Depth: 27 mm (1-1/16")
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2020 international standards.
*2 The operating environment temperature should be between 0 °C (32 °F) and 40 °C (104 °F) if the projector is used at an altitude between 1 400 m
(4 593') and 4 200 m (13 780') above sea level. Note that altitude of 4 200 m (13 780') above sea level is the maximum height that the performance
of this projector is guaranteed.
*3 The operating environment temperature should be between 0 °C (32 °F) and 40 °C (104 °F) when the optional Wireless Module (Model No.:
AJ-WM50 Series) is attached.
*4 When the operating environment temperature exceeds the following value, the light output may be reduced to protect the projector.
f When using the projector at an altitude lower than 1 400 m (4 593') above sea level: 35 °C (95 °F)
f When using the projector at an altitude between 1 400 m (4 593') and 2 700 m (8 858') above sea level: 30 °C (86 °F)
f When using the projector at an altitude between 2 700 m (8 858') and 4 200 m (13 780') above sea level: 25 °C (77 °F)
*5 Average value. Weight varies for each product.
*6 To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module (Model No.: AJ-WM50 Series).
Note
f The model numbers of accessories and optional accessories are subject to change without prior notice.

Table of Contents

Related product manuals