Panasonic PT-RQ25K Series

To Next Page

To Previous Page

Chapter 4 Settings — Menu navigation

ENGLISH - 107

Sub-menu item Factory default [SIMPLE] mode Page

[PROJECTOR NAME] ―

223

[NETWORK STATUS] ―

223

[NFC SETTING] [READ/WRITE] ― 224

[ADMINISTRATOR ACCOUNT] ―

225

[NETWORK SECURITY] ― ― 227

[NETWORK CONTROL] ―

228

[PJLink] ―

228

[Art-Net] ― ― 230

*1 [ETHERNET TYPE] and [DIGITAL LINK] cannot be set if the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is not installed in the

slot.

*2 [WIRELESS LAN] cannot be set if the optional Wireless Module (Model No.: AJ-WM50 Series) is not attached to the <USB> terminal.

Note

f Some items may not be adjusted or used for certain signal formats to be input to the projector.

When the items cannot be adjusted or used, the items in the menu screen are shown in black characters, and they cannot be adjusted or

set.

f Sub-menu items and factory default settings vary depending on the selected input terminal.

f The [NETWORK] menu → [NFC SETTING] is displayed when the NFC function is enabled.

The optional NFC Upgrade Kit (Model No.: ET-NUK10) can be used to enable the NFC function of the projector. Note that there are some

models that have the NFC function enabled from the time of factory shipment, and there are some countries or regions where the NFC

Upgrade Kit cannot be applied.

For the availability of the NFC function in the country or region where you purchased the product, visit the following website or consult your

dealer.

https://panasonic.net/cns/projector/

Panasonic PT-RQ25K Series - Page 107