Chapter 4 Settings — [ADVANCED MENU] menu
ENGLISH - 127
Blanking correction Item Operation Adjustment Range of adjustment
Top of the screen [UPPER]
Press q.
The blanking zone
moves upward.
PT-RQ25K/PT-RQ18K:
Top and bottom 0 - 2398
PT-RZ24K/PT-RZ17K:
Top and bottom 0 - 1198
Press w.
The blanking zone
moves downward.
Bottom of the
screen
[LOWER]
Press w.
The blanking zone
moves upward.
Press q.
The blanking zone
moves downward.
Left side of the
screen
[LEFT]
Press w.
The blanking zone
moves to the right.
PT-RQ25K/PT-RQ18K:
Left and right 0 - 3838
PT-RZ24K/PT-RZ17K:
Left and right 0 - 1918
Press q.
The blanking zone
moves to the left.
Right side of the
screen
[RIGHT]
Press q.
The blanking zone
moves to the right.
Press w.
The blanking zone
moves to the left.
Note
f The upper limit of the adjustment range may be restricted so that the entire projected image is not covered by blanking width.
f The [CUSTOM MASKING] setting in [BLANKING] is disabled in the following cases, and the masking function of the “Geometric & Setup
Management Software” cannot be used.
g When [QUAD PIXEL DRIVE] is set to [OFF]
g When using PT-RQ25K/PT-RQ18K and the image of 720/120p or 1080/120p is displayed
“Geometric & Setup Management Software” can be downloaded from the following website.
https://panasonic.net/cns/projector/pass/
It is necessary to register and login to PASS to download.
[EDGE BLENDING]
The overlapping area is made seamless by creating inclination in the brightness in the overlapped area when
structuring a multi-display screen by combining the projected images from multiple projectors.
Perform the edge blending adjustment when the projected image has stabilized.
When using the Zoom Lens (Model No.: ET-D3LEW200) or the Fixed-focus Lens (Model No.: ET-D3LEU100), it is
recommended to adjust the image after at least an hour has elapsed with the focus test pattern displayed.
When using a projection lens other than the Zoom Lens (Model No.: ET-D3LEW200) and the Fixed-focus Lens
(Model No.: ET-D3LEU100), it is recommended to adjust the image after at least 30 minutes have elapsed with
the focus test pattern displayed. For details of the test pattern, refer to “[TEST PATTERN] menu” (x page 209).
1) Press as to select [EDGE BLENDING].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Sets the edge blending function to off.
[ON] Use the setting value preset in the projector for the inclination of the edge blending area.
[USER]
Use the user-setting value for the inclination of the edge blending area. (Conguration/registration
requires separate software. Consult your dealer.)
f Proceed to Step 3) when anything other than [OFF] is selected.
3) Press the <ENTER> button.
f The [EDGE BLENDING] screen is displayed.
4) Press as to select [MODE].
To Next Page
Loading...
