Chapter 4 Settings — [PROJECTOR SETUP] menu
200 - ENGLISH
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE] Disables the <FUNCTION> button.
[SUB MEMORY]
Displays the sub memory list. (x page 214)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input is SDI
g The [DISPLAY OPTION] menu → [SLOT IN] → [SYSTEM SELECTOR]
f When the input is anything other than SDI
The [PICTURE] menu → [SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 113)
[FREEZE]
Temporarily pauses the image. (x page 163)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (x page 163)
[LENS MEMORY LOAD]
Loads the registered lens memory. (x page 168)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (x page 165)
[GEOMETRY]
Switches the [GEOMETRY] setting. (x page 120)
[LEFT/RIGHT SWAP]
*1
Switches the [LEFT/RIGHT SWAP] setting. (x page 136)
*1 PT-RZ24K/PT-RZ17K only
4) Press the <ENTER> button.
Note
f The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE] Displays the type of the projector.
[SERIAL NUMBER] Displays the serial number of the projector.
[PROJECTOR RUNTIME] Displays the runtime of the projector.
[LIGHT RUNTIME] Displays the runtime of the light source.
[CONTINUOUS LIGHTING
TIME]
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be conrmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
[FIRMWARE VERSION] Displays the rmware version of the projector.
[INTAKE AIR TEMP.]
*1
Displays the intake air temperature status.
[EXHAUST AIR TEMP.]
*1
Displays the exhaust air temperature status.
[SELF TEST] Displays the self-diagnosis information.
[INPUT]
Displays the currently selected input.
Displays the representative input terminal when one image is displayed with multiple input signals.
[SIGNAL NAME] Displays the input signal name.
[MEMORY NO.] Displays the memory number of the input signal.
[BACKUP INPUT STATUS]
Displays whether switching to the backup input signal is possible or not when [BACKUP INPUT
MODE] is set to [OFF]. (x page 142)
To Next Page
Loading...
