Panasonic PT-RQ25K Series

Chapter 5 Operations — Updating the rmware
ENGLISH - 291
Updating the rmware
The rmware of the projector can be updated via LAN or using a USB memory.
Firmware that can be uploaded can be downloaded from the following website (“Panasonic Professional Display
and Projector Technical Support Website”). Customer can update the rmware if a newer version than the current
rmware version is published.
https://panasonic.net/cns/projector/pass/
It is necessary to register and log in to PASS
*1
to conrm the availability of the rmware that can be updated or to
download the rmware.
*1 PASS: Panasonic Professional Display and Projector Technical Support Website
r How to conrm the rmware version
Current rmware version can be conrmed by pressing the <STATUS> button on the remote control and
displaying the [STATUS] screen.
The rmware version can also be conrmed in the [PROJECTOR SETUP] menu → [STATUS].
10000h
10000h
1/6
1.00
1h 23m
123456789012
31°C/87°F
31°C/87°F
MENU
EXITCHANGE
ENTER
E-MAIL/USB
SELF TEST
NO ERRORS
EXHAUST AIR TEMP.
FIRMWARE VERSION
INTAKE AIR TEMP.
CONTINUOUS LIGHTING TIME
LIGHT RUNTIME
PROJECTOR RUNTIME
PROJECTOR TYPE
STATUS
PT-RQ25K
SERIAL NUMBER
Note
f A LAN cable is required to connect to the network via wired LAN.
Updating the rmware via LAN
Example of network connection
Computer
Projector
LAN cable (straight) LAN cable (straight)
Switching Hub
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
Note
f A LAN cable is required to connect to the network via wired LAN.
f Connect the LAN cable to the <LAN> terminal equipped on the projector as standard or the <DIGITAL LINK IN/LAN> terminal of the optional
DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) installed in the slot.
f To connect to the network using the <LAN> terminal, set the [NETWORK] menu → [ETHERNET TYPE] to [LAN] or [LAN & DIGITAL LINK].
f Update cannot be performed using the “IPv6” protocol. Set the [NETWORK] menu → [WIRED LAN] → [IP VERSION] to either [IPv4] or
[IPv4 & IPv6] and assign the IP address for “IPv4”.