Panasonic PT-RQ25K Series

Chapter 3 Basic Operations — Operating with the remote control
ENGLISH - 99
2) Press the <TEST PATTERN> button again.
f The test pattern and the [TEST PATTERN] screen (list format) are displayed.
f The [TEST PATTERN] screen (list format) can also be displayed by pressing the <ENTER> button while
[TEST PATTERN] is selected in the main menu screen.
3) Press as to select the test pattern to display, and press the <ENTER> button.
f Selected test pattern and the [TEST PATTERN] screen (toggle selection format) are displayed.
f To change the test pattern, proceed to Step 4).
4) Press qw to switch the test pattern.
f The test pattern will switch each time you press qw.
Note
f The main menu screen and the [TEST PATTERN] screen (list format, toggle selection format) can be hidden by pressing the <ON
SCREEN> button on the remote control while the test pattern is displayed.
f Test patterns can also be displayed using the menu operation. Refer to “[TEST PATTERN] menu” (x page 209) for details.
f Settings of position, size, and other factors will not be reected in test patterns. Make sure to perform various adjustments while displaying
the input image.
Using the status function
Display the status of the projector.
button
1) Press the <STATUS> button.
f The [STATUS] screen is displayed.
10000h
10000h
1/6
1.00
1h 23m
123456789012
31°C/87°F
31°C/87°F
MENU
EXITCHANGE
ENTER
E-MAIL/USB
SELF TEST
NO ERRORS
EXHAUST AIR TEMP.
FIRMWARE VERSION
INTAKE AIR TEMP.
CONTINUOUS LIGHTING TIME
LIGHT RUNTIME
PROJECTOR RUNTIME
PROJECTOR TYPE
STATUS
PT-RQ25K
SERIAL NUMBER
Note
f The projector status can also be displayed using the menu operation. Refer to the [PROJECTOR SETUP] menu → [STATUS]
(x page 200) for details.
Setting ID number of the remote control
When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using a single remote control, if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same ID number on the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID
ALL> button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on
the remote control even if you do not know the projector ID.
button
1) Press the <ID SET> button on the remote control.