Chapter 1 Preparation — Precautions for use
ENGLISH - 23
rProjection in all 360° direction is possible.
360°
360°
360°
360° vertically 360° horizontally 360° tilted
(combination of vertical and horizontal)
Cautions when setting up the projector
f Install the projector in a place or with a mount that can sufciently tolerate the weight. The position of the
projected image may shift if the strength is not sufcient.
f Use the adjustable feet only for the oor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f The adjustable feet can be removed if not needed in the installation. However, do not use the screw holes
where the adjustable feet were removed for any other purpose such as xing the projector to a mount.
Also, do not attach any screws not instructed in the operating instructions of the optional accessories into the
screw holes where the adjustable feet are removed. Doing so may damage the projector.
f When using the projector in any method other than the oor installation using the adjustable feet or ceiling
mounting installation using the Ceiling Mount Bracket, remove the four adjustable feet and use the six screw
holes (as shown in the gure) to x the projector to a mount.
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f Use a torque screwdriver or Allen torque wrench to tighten the xing screws to their specied tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
For the screws to x the projector, use commercially available ISO 898-1 standard screws (made of carbon steel
or alloy steel).
(Screw diameter: M6, tapping depth inside the projector: 16 mm (5/8"), screw tightening torque: 4 ± 0.5 N·m)
Positions of screw holes to fix projector and
adjustable feet
Adjustable feet
Mount
M6
Thread engagement depth
Screw holes to fix the projector
Unit: mm
Adjustable feet
16 (5/8")
To Next Page
Loading...
