Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 83
6) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 57)
7) Press the <SHIFT> button to adjust the position of the projected image.
8) Press the <ZOOM> button to match the projected image size to the screen.
9) Press the <FOCUS> button again to adjust the focus.
10) Press the <ZOOM> button again to adjust the zoom and match the projected image size to the screen.
Note
f When the projector is switched on for the rst time after purchase, or when the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY
RESET] is executed, the focus adjustment screen is displayed after the projection starts, followed by the [INITIAL SETTING] screen and
the [ADMINISTRATOR ACCOUNT] screen. If the [PROJECTOR SETUP] menu → [INITIALIZE] → [NETWORK/E-MAIL ONLY] is executed,
the [ADMINISTRATOR ACCOUNT] screen is displayed after the projection starts. For details, refer to “When the initial setting screen is
displayed” (x page 75), “When the administrator account setting screen is displayed” (x page 81).
Switching off the projector
1)
2)
4)
3)
1)
2)
1) Press the <STANDBY> button.
f The [POWER OFF(STANDBY)] conrmation screen is displayed.
2) Press qw to select [OK], and press the <ENTER> button.
(Or press the <STANDBY> button again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks in red.
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Attention
f When switching off the projector, make sure to follow the procedures described. Failure to do so may damage the internal components and
result in malfunctions.
Note
f Even when the <STANDBY> button is pressed and the projector is switched off, the projector consumes power if the main power
of the projector is on.
Usage of some functions is restricted but the power consumption during the standby mode is conserved when the [PROJECTOR SETUP]
menu → [STANDBY MODE] is set to [ECO].
To Next Page
Loading...
