Chapter 4 Settings — [PICTURE] menu
ENGLISH - 117
4) Press the <ENTER> button.
Note
f For details of the types of image signals that can be used with the projector, refer to “List of compatible signals” (x page 327).
f This may not function properly depending on the connected external device.
f The selection item for the DIGITAL LINK input can be selected when the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is
installed in the slot.
f The selection item for the PressIT input can be selected when the optional Wireless Presentation System Receiver Board (Model No.:
TY-SB01WP) is installed in the slot.
f The selection item for the SLOT input can be selected when the Function Board from other manufacturers is installed in the slot.
f For the SDI input, the signal format can be set in detail in the [DISPLAY OPTION] menu → [SLOT IN].
sRGB-compliant image
sRGB is an international standard (IEC61966-2-1) for color reproduction dened by IEC (International
Electrotechnical Commission).
Set according to the following steps to reproduce more faithful, sRGB compliant colors.
1) Set [COLOR MATCHING] to [OFF].
f Refer to [COLOR MATCHING] (x page 139).
2) Display the [PICTURE] menu.
f Refer to “[PICTURE] menu” (x page 108).
3) Press as to select [PICTURE MODE].
4) Press qw to set [NATURAL].
5) Press as to select [COLOR].
6) Press the <DEFAULT> button on the remote control to set the factory default setting.
7) Follow Steps 5) to 6) to set [TINT], [COLOR TEMPERATURE], [GAMMA], and [SYSTEM DAYLIGHT
VIEW] to the factory default settings.
Note
f sRGB is available for RGB signal input only.
To Next Page
Loading...
