Panasonic PT-RQ25K Series

Chapter 4 Settings — [NETWORK] menu
ENGLISH - 221
Note
f [DIGITAL LINK MENU] cannot be selected when [EXTRON XTP] is set to [ON].
f The operation guidance for the “RETURN” button is in the menu screen of the Digital Interface Box and DIGITAL LINK Switcher. The
projector does not have the “RETURN” button, but the same operation is available with the <MENU> button.
[EXTRON XTP]
Perform the connection setting for the “XTP transmitter” of Extron Electronics.
1) Press as to select [DIGITAL LINK].
2) Press the <ENTER> button.
f The [DIGITAL LINK] screen is displayed.
3) Press as to select [EXTRON XTP].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Select this item when connecting the optional DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) to the <DIGITAL LINK IN/LAN> terminal.
[ON]
Select this item when connecting the “XTP transmitter” of Extron Electronics to the <DIGITAL LINK
IN/LAN> terminal.
Note
f For details of the “XTP transmitter”, visit the following website of Extron Electronics.
https://www.extron.com/
[WIRED LAN]
Perform the connection setting to use the wired LAN.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED LAN] screen is displayed.
3) Press as to select [IP VERSION].
4) Press the <ENTER> button.
f The [IP VERSION] screen is displayed.
5) Press as to select the item to set, and press the <ENTER> button.
[IPv4] Uses only the “IPv4” protocol.
[IPv6] Uses only the “IPv6” protocol.
[IPv4 & IPv6] Both the “IPv4” and the “IPv6” protocols can be used.
6) Press the <MENU> button.
f The [WIRED LAN] screen is displayed.
f Proceed to Step 12) when [IPv6] is selected.
7) Press as to select [IPv4 SETTINGS], and press the <ENTER> button.
f The [IPv4 SETTINGS] screen is displayed.
8) Press as to select an item, and change the settings according to the operation instructions of the
menu.
[DHCP]
[ON]
Select this item when using the DHCP server that exists in the
network to which the projector is to be connected. IPv4 address is
automatically acquired.
[OFF]
Select this item when setting the IPv4 address manually.
Set [IP ADDRESS], [SUBNET MASK], and [DEFAULT GATEWAY].
[IP ADDRESS] Enter the IP address.
[SUBNET MASK] Enter the subnet mask.
[DEFAULT GATEWAY] Enter the default gateway address.